Water Pump: Removal

WARNING: This page is about a different variant/trim than selected.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ENGINE UNDER COVER LH
REMOVE ENGINE UNDER COVER RH
DRAIN ENGINE COOLANT (See COOLANT )
REMOVE V-RIBBED BELT (See ON-VEHICLE INSPECTION )
REMOVE GENERATOR ASSEMBLY (See REMOVAL )
REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH (See REMOVAL )
REMOVE WATER PUMP PULLEY
1. Using SST, remove the 4 bolts and water pump pulley.
  SST 09960-10010 (09962-01000, 09963-00700)
  
  Fig 1: Removing Water Pump Pulley
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE WATER PUMP ASSEMBLY
1. Remove the clamp of the crankshaft position sensor from the water pump.
2. Disconnect the wire of the crankshaft position sensor from the clamp bracket.
  
  Fig 2: Locating Crankshaft Position Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 4 bolts, 2 nuts and clamp bracket.
  
  Fig 3: Locating Clamp Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.
  HINT:
  
  Tape the screwdriver tip before use.
  
  NOTE: Be careful not to damage the contact surfaces of the water pump and cylinder block.
  
  Fig 4: Removing Water Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002