Section 6 (Charging System (2AZ-FE)): Generator: Removal

WARNING: This page is about a different variant/trim than selected.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ENGINE UNDER COVER RH
REMOVE V-RIBBED BELT (See ON-VEHICLE INSPECTION )
REMOVE GENERATOR ASSEMBLY
1. Disconnect the generator connector.
2. Remove the nut and disconnect the wire harness from terminal B.
3. Separate the 2 wire harness clamps.
  
  Fig 1: Locating Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 bolts and generator assembly.
  
  Fig 2: Locating Generator Assembly And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the bolt and wire harness clamp bracket.
  
  Fig 3: Locating Bolt And Wire Harness Clamp Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002