On-Vehicle Inspection

1. CHECK V-RIBBED BELT 

1. Check the belt for wear, cracks or other signs of damage.

   If any of the following defects is found, replace the V-ribbed belt.

   • The belt is cracked.
   • The belt is worn out to the extent that cords are exposed.
   • The belt has chunks missing from the ribs.
   Fig 1: Identifying Drive Belt Condition

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check that the belt fits properly in the ribbed grooves.

HINT:

Check by hand to confirm that the belt has not slipped out of the groove on the bottom to the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.

Fig 2: Identifying V-Ribbed Belt Correct And Incorrect Position

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002