Park / Neutral Position Switch: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch assembly to the automatic transaxle.
  
  Fig 1: Locating Park/Neutral Position Switch Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Temporarily install the 2 bolts.
  
  Fig 2: Locating Park/Neutral Position Switch Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Replace the lock plate with a new one and tighten the manual valve shaft nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
4. Temporarily install the control shaft lever.
  
  Fig 3: Locating Manual Valve Shaft Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
6. Remove the control shaft lever.
  
  Fig 4: Turning Lever Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Align the groove with the neutral basic line.
8. Hold the switch in place and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 5: Identifying Groove And Neutral Basic Line With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Using a screwdriver, stake the nut with the lock plate.
  
  Fig 6: Staking Nut With Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Install the control shaft lever with the nut and washer.
  Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
11. Connect the connector to the park/neutral position switch assembly.
Fig 7: Locating Control Shaft Lever Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
1. Install the transmission control cable assembly to the control shaft lever with the nut.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
2. Install the transmission control cable assembly to the bracket with a new clip.
Fig 8: Locating Transmission Control Cable Assembly Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SHIFT LEVER POSITION (See INSPECTION )
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See INSPECTION )
INSTALL ENGINE UNDER COVER LH