Park / Neutral Position Switch: Inspection

WARNING: This page is about a different variant/trim than selected.

INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Disconnect the park/neutral position switch connector.

Fig 1: Locating Park/Neutral Position Switch Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Measure the resistance according to the value(s) in the table below.

Fig 2: Identifying Park/Neutral Position Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard Resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
2 - 6 and 4 - 5	P position	Below 1 Ω
	Except P position	10 kΩ or higher
2-1	R position	Below 1 Ω
	Except R position	10 kΩ or higher
2 - 9 and 4 - 5	N position	Below 1 Ω
	Except N position	10 kΩ or higher
2-7	D position and 3 position	Below 1 Ω
	Except D position and 3 position	10 kΩ or higher
2-3	2 position	Below 1 Ω
	Except 2 position	10 kΩ or higher
2-8	L position	Below 1 Ω
	Except L position	10 kΩ or higher

If the result is not as specified, replace the park/ neutral position switch.