Park / Neutral Position Switch: Adjustment

WARNING: This page is about a different variant/trim than selected.

ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Loosen the bolts of the park/neutral position switch and move the shift lever to N.
  
  Fig 1: Locating Park/Neutral Position Switch Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Align the groove with the neutral basic line.
  
  Fig 2: Identifying Groove And Neutral Basic Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Hold the switch in place and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
4. After the adjustment, perform the switch operation check (See ON-VEHICLE INSPECTION ).