Ignition Coil And Spark Plug: Installation

INSTALL SPARK PLUG
1. Install the 6 spark plugs.
  Torque: 18 N*m (183 kgf*cm, 13 ft.*lbf)
  
  Fig 1: Identifying Spark Plugs
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL IGNITION COIL ASSEMBLY
1. Install the 6 ignition coils with the 6 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
2. Connect the 6 ignition coil connectors.
  
  Fig 2: Identifying Ignition Coil Connectors With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 4 bolts [A].
  Torque: 8.3 N*m (84 kgf*cm, 73 in.*lbf)
4. Install the nut [B].
  Torque: 8.3 N*m (84 kgf*cm, 73 in.*lbf)
5. Install the 2 clamps [C].
INSTALL INTAKE AIR SURGE TANK ASSEMBLY (See INSTALLATION )
TEMPORARILY INSTALL NO. 1 SURGE TANK STAY (See INSTALLATION )
TEMPORARILY INSTALL THROTTLE BODY BRACKET (See INSTALLATION )
FULLY TIGHTEN NO. 1 SURGE TANK STAY (See INSTALLATION )
FULLY TIGHTEN THROTTLE BODY BRACKET (See INSTALLATION )
CONNECT ENGINE ROOM MAIN WIRE (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (See INSTALLATION )
INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
ADD ENGINE COOLANT (See REPLACEMENT )
INSPECT FOR ENGINE COOLANT LEAK (See ON-VEHICLE INSPECTION )
INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )
INSTALL ENGINE UNDER COVER ASSEMBLY (See INSTALLATION )