Drive Belt: Removal

REMOVE FRONT WHEEL RH
REMOVE ENGINE UNDER COVER ASSEMBLY (See REMOVAL )
REMOVE NO. 1 ENGINE UNDER COVER (See REMOVAL )
REMOVE FRONT FENDER MOLDING SUB-ASSEMBLY RH
1. Remove the clip.
  
  Fig 1: Identifying Front Fender Molding Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a 4 mm hexagon wrench, remove the screw.
3. Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender molding sub-assembly RH.
  
  Fig 2: Identifying Front Fender Side Protector Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the pad from the front fender molding sub-assembly RH.
5. Remove the 2 clips No. 4 from the front fender molding sub-assembly RH.
6. Remove the front fender side protector from the front fender molding sub-assembly RH.
  
  Fig 3: Identifying Front Fender Side Protector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT FENDER LINER RH (See REMOVAL )
REMOVE FRONT FENDER APRON SEAL RH (See REMOVAL )
REMOVE V-RIBBED BELT
1. Using SST, release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, and remove the V-ribbed belt from the V-ribbed belt tensioner assembly.
  
  Fig 4: Releasing V-Ribbed Belt Tension Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  SST 09961-00950
2. While turning the V-ribbed belt tensioner assembly counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner assembly.
  
  Fig 5: Inserting Bi-Hexagon Wrench Into Holes To Fix V-Ribbed Belt Tensioner
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002