FENDER LINER (for Front Side): Removal

REMOVE ENGINE UNDER COVER ASSEMBLY (See REMOVAL )
REMOVE NO. 1 ENGINE UNDER COVER (See REMOVAL )
REMOVE FRONT FENDER MOLDING SUB-ASSEMBLY LH (See REMOVAL )
REMOVE FRONT FENDER MOLDING SUB-ASSEMBLY RH
HINT:

Use the same procedures for the RH side and LH side.
REMOVE FRONT WHEEL OPENING EXTENSION PAD (for LH Side)
1. Remove the 2 screws and front wheel opening extension pad.
  
  Fig 1: Identifying Front Wheel Opening Extension Pad Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT WHEEL OPENING EXTENSION PAD (for RH Side)
HINT:

Use the same procedure for the RH side and LH side.
REMOVE FRONT FENDER LINER LH
1. Remove the screw.
2. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
  
  Fig 2: Turning Pin & Removing Pin Hold Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a 4 mm hexagon wrench, remove the 2 screws.
4. Remove the 2 grommets.
  HINT:
  
  The grommets need to be replaced with new ones because they will break when they are removed.
  
  Fig 3: Identifying Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 5 clips, 8 screws and front fender liner LH.
  
  Fig 4: Identifying Front Fender Liner LH Clips & Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT FENDER LINER RH
1. Remove the screw.
2. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
  
  Fig 5: Identifying Pin Hold Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a 4 mm hexagon wrench, remove the 2 screws.
  
  Fig 6: Identifying Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 grommets.
  HINT:
  
  The grommets need to be replaced with new ones because they will break when they are removed.
5. Remove the 5 clips, 7 screws and front fender liner RH.
  
  Fig 7: Identifying Front Fender Liner RH Clips & Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002