Side Mudguard: Removal

HINT:

When removing the side mudguard, heat the vehicle body and side mudguard using a heat light.

Heating temperature

ITEM TEMPERATURE TABLE

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)
Side Mudguard	20 to 30°C (68 to 86°F)

NOTE: Do not heat the vehicle body or side mudguard excessively.

REMOVE FRONT FENDER MOLDING SUB-ASSEMBLY
1. Remove the clip.
2. Using a 4 mm hexagon wrench, remove the screw.
  
  Fig 1: Identifying Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender molding sub-assembly.
  
  Fig 2: Identifying Front Fender Molding Sub-Assembly Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the pad from the front fender molding sub-assembly.
5. Remove the 2 No. 4 clips from the front fender molding sub-assembly.
6. Remove the front fender side protector from the front fender molding sub-assembly.
  
  Fig 3: Identifying Front Fender Side Protector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT FENDER OUTSIDE MOLDING PAD
1. Remove the front fender outside molding pad from the front fender molding sub-assembly.
  
  Fig 4: Identifying Front Fender Outside Molding Pad
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT DOOR OUTSIDE MOLDING SUB-ASSEMBLY
1. Turn back the front door weatherstrip.
2. Remove the nut.
  
  Fig 5: Identifying Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Peel off the upper front door outside molding pad and disengage the 11 clips, and then remove the front door outside molding sub-assembly.
4. Remove the gasket from the front door outside molding sub-assembly.
5. Remove the 3 No. 3 clips from the front door outside molding sub-assembly.
6. Remove the 8 No. 4 clips from the front door outside molding sub-assembly.
  
  Fig 6: Identifying Front Door Outside Molding Sub-Assembly Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the upper front door outside molding pad from the front door outside molding sub-assembly.
  
  Fig 7: Identifying Upper Front Door Outside Molding Pad
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR DOOR OUTSIDE MOLDING SUB-ASSEMBLY
1. Turn back the rear door No. 2 weatherstrip.
2. Remove the nut.
  
  Fig 8: Identifying Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Peel off the upper rear door outside molding pad and disengage the 8 clips, and then remove the rear door outside molding sub-assembly.
4. Remove the gasket from the rear door outside molding sub-assembly.
5. Remove the 2 No. 3 clips from the rear door outside molding sub-assembly.
6. Remove the 6 No. 4 clips from the rear door outside molding sub-assembly.
  
  Fig 9: Identifying Rear Door Outside Molding Sub-Assembly Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the upper rear door outside molding pad from the rear door outside molding sub-assembly.