Camshaft Timing Oil Control Valve Assembly: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
1. Apply a light coat of engine oil to a new O-ring and install it onto the camshaft timing oil control valve assembly.
  NOTE: Do not twist the O-ring.
  
  Fig 1: Identifying Camshaft Timing Oil Control Valve Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the camshaft timing oil control valve assembly with the bolt.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
  
  Fig 2: Identifying Camshaft Timing Oil Control Valve Assembly With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the camshaft timing oil control valve assembly connector.
  
  Fig 3: Identifying Camshaft Timing Oil Control Valve Assembly Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FAN BELT ADJUSTING BAR
1. Provisionally install the fan belt adjusting bar with the bolt and nut.
2. Tighten the nut to the specified torque.
  Torque: 11 N*m (112 kgf*cm, 8.1 ft.*lbf)
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
ADJUST FAN AND GENERATOR V BELT (See INSTALLATION )
INSPECT FAN AND GENERATOR V BELT (See INSPECTION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
CHECK FOR ENGINE OIL LEAKAGE
INSTALL CYLINDER HEAD COVER NO. 2 (See INSTALLATION )
INSTALL ENGINE UNDER COVER RH