Transmission Wire: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION WIRE
1. Coat a new O-ring with ATF and install it into the transmission wire.
  
  Fig 1: Identifying O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pass the transmission wire through the transaxle.
  
  Fig 2: Identifying Transmission Wire Through Transaxle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the transmission wire with the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 3: Identifying Bolt And Transmission Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION VALVE BODY ASSEMBLY (See INSTALLATION )
INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See INSTALLATION )
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUBASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
ADD AUTOMATIC TRANSAXLE FLUID (See INSTALLATION )
INSPECT AUTOMATIC TRANSAXLE FLUID (See AUTOMATIC TRANSAXLE FLUID )
CHECK FOR AUTOMATIC TRANSAXLE FLUID LEAKAGE
INSTALL ENGINE UNDER COVER LH