Inspection Procedure
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is necessary to register the transmitter IDs after replacing the tire pressure warning valve and transmitter and/or the tire pressure warning ECU (See REGISTRATION
).
- CHECK DTC OUTPUT (C2176/76)
- Clear the DTC (See DTC CHECK/CLEAR ).
- Turn the ignition switch OFF.
- Turn the ignition switch ON and check for DTCs (See DTC CHECK/CLEAR
).
OK: DTC C2176/76 is not output.
NG: REPLACE TIRE PRESSURE WARNING ECU (See REMOVAL )
OK: END