DTC Check/Clear

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DTC CHECK (USING TECHSTREAM)
1. Turn the ignition switch OFF.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch ON.
4. Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
5. Read the DTCs following the prompts on the Techstream screen.
  HINT:
  
  Refer to the Techstream operator's service information for further details.
  
  Fig 1: Tire Pressure Warning Light - Blinking Pattern
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

CHECK DTC (USING SST CHECK WIRE)

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
SST 09843-18040
Turn the ignition switch ON.

Fig 2: Identifying DLC3 Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration for examples of a normal system code and DTCs 13 and 33.

HINT:

If the tire pressure warning light does not blink to indicate any DTCs or the normal system code, inspect the tire pressure warning light circuit or 13 (TC) and 4 (CG) terminal circuits.

SYMPTOM CHART

Trouble Area	See procedure
Tire pressure warning light circuit	TIRE PRESSURE WARNING LIGHT CIRCUIT
TC and CG terminal circuit	TC AND CG TERMINAL CIRCUIT

If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.

Refer to the Diagnostic Trouble Code Chart for DTC information (See DIAGNOSTIC TROUBLE CODE CHART ).
After completing the check, turn the ignition switch OFF and remove SST from the DLC3.

Fig 3: Tire Pressure Warning Light - Blinking Pattern
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

CLEAR DTC (USING TECHSTREAM)
HINT:

After repairing the malfunctions, clear the DTCs.
1. Turn the ignition switch OFF.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch ON.
4. Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
5. Erase the DTCs following the prompts on the Techstream screen.
  HINT:
  
  Refer to the Techstream operator's service information for further details.