Tire Pressure Warning System: Registration

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DESCRIPTION OF CODE REGISTRATION
It is necessary to register the transmitter ID in the tire pressure warning ECU when replacing the tire pressure warning valve and transmitter and/or tire pressure warning ECU.

Prepare all transmitter ID data before starting registration.
1. Before registration
  1. If replacing the tire pressure warning ECU:
    - Read the registered transmitter IDs that are stored in the old ECU using the Techstream and note them down.
    - If reading stored transmitter ID is impossible due to malfunctions of components such as the tire pressure warning antenna and receiver, remove the tires from the wheels and check the ID located on the tire pressure warning valve and transmitter (See TIRE PRESSURE WARNING SYSTEM ).
  2. If replacing a tire pressure warning valve and transmitter:
    - Take a note of the 7-digit number (transmitter ID) written on the tire pressure warning valve and transmitter.
      
      Fig 1: Identifying Transmitter ID Number On Tire Pressure Warning Valve
      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE: The transmitter ID is written on the tire pressure warning valve and transmitter. It will be unable to be read after installing the tire pressure warning valve and transmitter on the tire and wheel. Therefore, take a note of the transmitter ID before installing the tire pressure warning valve and transmitter.
REGISTER TRANSMITTER ID
1. Set the pressure of all the wheels to the specified value (See TIRE PRESSURE WARNING SYSTEM ).
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch ON.
4. Turn the Techstream on.
5. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
6. Perform the following procedures displayed on the screen.
7. Confirm of transmitter ID registration.
  1. Enter the following menus: Chassis / Tire Pressure Monitor/ Data List.
  2. Read the "ID Tire Inflation Pressure" values.
  3. Confirm that the data of tire pressure of all tires are displayed on the screen.
    NOTE:
    It may take about 2 or 3 minutes to update the tire pressure data. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25 (See DTC C2121/21 NO SIGNAL FROM TRANSMITTER ID1; DTC C2122/22 NO SIGNAL FROM TRANSMITTER ID2; DTC C2123/23 NO SIGNAL FROM TRANSMITTER ID3; DTC C2124/24 NO SIGNAL FROM TRANSMITTER ID4; DTC C2125/25 NO SIGNAL FROM TRANSMITTER ID5; DTC C2181/81 TRANSMITTER ID1 NOT RECEIVED (TEST MODE DTC); DTC C2182/82 TRANSMITTER ID2 NOT RECEIVED (TEST MODE DTC); DTC C2183/83 TRANSMITTER ID3 NOT RECEIVED (TEST MODE DTC); DTC C2184/84 TRANSMITTER ID4 NOT RECEIVED (TEST MODE DTC); DTC C2185/85 TRANSMITTER ID5 NOT RECEIVED (TEST MODE DTC) ).
    
    If the IDs have not been registered, DTC C2171/71 is set in the tire pressure warning ECU after 3 minutes or more.
    
    If normal pressure valves are displayed, the IDs have been registered correctly.
    
    If the tire pressure valves are not displayed after a few minutes, the IDs may be incorrect or the system may have a malfunction.
    
    After all IDs are registered, DTC C2126/26 (Transmitter ID not Received in Main Mode) is set in the tire pressure warning ECU and the tire pressure warning light blinks for 1 minute and then comes on. When the tire pressure warning ECU successfully receives radio waves from all the transmitters whole IDs are stored in the ECU, DTC C2126/26 is deleted and the tire pressure warning light goes off.