LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Tire And Wheel) >> TIRE PRESSURE WARNING RECEIVER (w/ Antenna) >> Installation

TIRE PRESSURE WARNING RECEIVER (w/ Antenna): Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TIRE PRESSURE WARNING ANTENNA AND RECEIVER 
    1. Install the receiver with the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

      Fig 1: Locating Receiver With Bolt
      G05584945Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the connector.
  2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH  (See INSTALLATION )
  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (w/o Rear No. 2 Seat)  (See INSTALLATION )
  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  5. INSTALL TETHER ANCHOR BRACKET SUB-ASSEMBLY (w/o Rear No. 2 Seat)  (See INSTALLATION )
  6. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL RH (w/o Rear No. 2 Seat)  (See INSTALLATION )
  7. INSTALL REAR DECK TRIM COVER RH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  8. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
  9. INSTALL REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE  (See INSTALLATION )
  10. INSTALL REAR FLOOR NO. 2 BOARD 
  11. INSTALL REAR FLOOR NO. 3 BOARD 
  12. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  13. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  14. INSTALL NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  15. INSTALL NO. 2 SEAT LEG COVER RH (w/Rear No. 2 Seat)  (See INSTALLATION )
  16. INSTALL NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  17. INSTALL NO. 2 SEAT HINGE COVER RH (w/Rear No. 2 Seat)  (See INSTALLATION )
  18. INSTALL DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat) 
  19. INSTALL REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat) 
  20. INSTALL TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat) 
  21. INSTALL PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/o Rear No. 2 Seat) 
  22. INSTALL REAR DOOR SCUFF PLATE RH  (See INSTALLATION )
  23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  24. REGISTER TRANSMITTER ID  (See REGISTRATION  )
  25. INSPECT TIRE PRESSURE WARNING SYSTEM 
scientia non olet · About LEMON Manuals