Differential Oil Seal: Replacement

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DRAIN AUTOMATIC TRANSAXLE FLUID
1. Remove the drain plug, gasket and drain ATF.
2. Install a new gasket and drain plug.
  Torque: 47 N*m (479 kgf*cm, 35 ft.*lbf)
REMOVE FRONT DRIVE SHAFT ASSEMBLY
1. Remove the drive shaft (see REMOVAL ).
REMOVE DRIVE SHAFT BEARING BRACKET
1. Remove the 3 bolts and bracket.
REMOVE TRANSAXLE HOUSING OIL SEAL LH AND RH
1. Using SST, tap out the oil seal LH.
  SST 09308-00010
  
  Fig 1: Identifying Tapping Out Oil Seal LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, tap out the oil seal RH.
  SST 09308-00010
  
  Fig 2: Identifying Tapping Out Oil Seal RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSAXLE HOUSING OIL SEAL LH AND RH
1. Coat the lip of a new oil seal LH with MP grease.
2. Using SST and a hammer, tap in the oil seal LH.
  SST 09608-32010, 09950-70010 (09951-07150)
  
  Standard depth:
  
  0 +- 0.5 mm (0 +- 0.020 In.)
  
  Fig 3: Identifying Tapping In Oil Seal LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Coat the lip of a new oil seal LH with MP grease.
4. Using SST and a hammer, tap in the oil seal RH.
  SST 09608-32010, 09950-70010 (09951-07150)
  
  Standard depth:
  
  0 +- 0.5 mm (0 +- 0.020 in.)
  
  Fig 4: Identifying Tapping In Oil Seal RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DRIVE SHAFT BEARING BRACKET
1. Install the bracket with the 3 bolts.
  Torque: 64 N*m (653 kgf*cm, 47 ft.*lbf)
INSTALL FRONT DRIVE SHAFT ASSEMBLY
1. Install the front drive shaft (see INSTALLATION ).
ADD AUTOMATIC TRANSAXLE FLUID
Fluid type:

Toyota Genuine ATF WS or Equivalent
INSPECT TRANSAXLE FLUID LEVEL
1. Inspect the transaxle fluid level (see ON-VEHICLE INSPECTION ).