LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 230 (Automatic Transmission - U241E) >> Automatic Transaxle Fluid >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK TRANSAXLE FLUID LEVEL 

    HINT:

    Drive the vehicle so that the engine and transaxle are at normal operating temperature.

    Fluid temperature: 

    70 to 80°C (158 to 176°F) 

    1. Park the vehicle on a level surface and set the parking brake.
    2. With the engine idling and the brake pedal depressed, move the shift lever to each position from P to L position, and return it to the P position.
    3. Take out the ATF dipstick and wipe it clean.
    4. Fig 1: Identifying ATF Dipstick
      G05584139Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Fully push the dipstick back into the pipe.
    6. Take it out and check that the fluid level is at the HOT position.

      If there are leaks, it is necessary to repair or replace O-rings, FIPGs, oil seals, plugs and/or other parts.