LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Audio System & Visual System) >> Radio Antenna Cord >> Installation

Radio Antenna Cord: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ANTENNA CORD SUB-ASSEMBLY 
    1. Install the antenna cord with the 4 clamps.
    2. Connect the connector.
      Fig 1: Identifying Antenna Cord Sub-Assembly Clamps
      G05184863Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY UPPER  (See INSTALLATION )
  3. INSTALL FRONT PILLAR GARNISH LH  (See INSTALLATION )
  4. INSTALL FRONT PILLAR GARNISH RH  (See INSTALLATION )
  5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY  (See INSTALLATION )
  6. INSTALL INSTRUMENT PANEL REGISTER ASSEMBLY CENTER  (See INSTALLATION )
  7. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)  (See INSTALLATION  )
  8. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER  (See INSTALLATION )
  9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER  (See INSTALLATION )
  10. INSTALL COMBINATION METER ASSEMBLY  (See INSTALLATION )
  11. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
scientia non olet · About LEMON Manuals