LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Seat Belt) >> REAR SEAT OUTER BELT ASSEMBLY (for Sedan) >> Removal

REAR SEAT OUTER BELT ASSEMBLY (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/o Rear Spoiler) 
  2. REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY 
    1. for 60/40 Split Seat Type:
      1. Remove the rear seat cushion cover pad (See REMOVAL ).
    2. for Fixed Seat Type:
      1. Remove the rear seat cushion cover pad (See REMOVAL ).
  3. REMOVE REAR SEATBACK ASSEMBLY RH (for 60/40 Split Seat Type)  (See REMOVAL )
  4. REMOVE REAR SEATBACK ASSEMBLY LH (for 60/40 Split Seat Type)  (See REMOVAL )
  5. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)  REMOVAL 
  6. REMOVE LUGGAGE COMPARTMENT FLOOR MAT (for 60/40 Split Seat Type)  (See DISASSEMBLY )
  7. REMOVE SPARE WHEEL COVER ASSEMBLY (for 60/40 Split Seat Type)  (See DISASSEMBLY )
  8. REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD (for 60/40 Split Seat Type)  (See DISASSEMBLY )
  9. REMOVE REAR DOOR SCUFF PLATE RH  (See REMOVAL )
  10. REMOVE REAR DOOR SCUFF PLATE LH  (See REMOVAL )
  11. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH  (See REMOVAL )
  12. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH  (See REMOVAL )
  13. REMOVE REAR SEAT SIDE COVER RH  (See REMOVAL )
  14. REMOVE REAR SEAT SIDE COVER LH  (See REMOVAL )
  15. REMOVE ROOF SIDE INNER GARNISH RH  (See REMOVAL )
  16. REMOVE ROOF SIDE INNER GARNISH LH  (See REMOVAL )
  17. REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY (w/o Rear Spoiler)  (See REMOVAL )
  18. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY  (See REMOVAL )
  19. REMOVE REAR SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt.
    2. Disengage the 2 claws and remove the anchor plate.
      Fig 1: Identifying Anchor Plate Claws And Bolts
      G04830708Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt, the hook and the retractor.
      Fig 2: Locating Hook And Retractor Bolt
      G04830709Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  20. REMOVE SEAT BELT HOLE SEAL 
    1. Disengage the 2 claws and remove the seat belt hole seal.
scientia non olet · About LEMON Manuals