REAR PACKAGE TRAY SPEAKER (for Sedan): Removal
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY
- REMOVE REAR SEATBACK ASSEMBLY RH (for 60/ 40 Split Seat Type) (See REMOVAL )
- REMOVE REAR SEATBACK ASSEMBLY LH (for 60/ 40 Split Seat Type) (See REMOVAL )
- REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type) REMOVAL
- REMOVE LUGGAGE COMPARTMENT FLOOR MAT (for 60/40 Split Seat Type) (See DISASSEMBLY )
- REMOVE SPARE WHEEL COVER ASSEMBLY (for 60/ 40 Split Seat Type) (See DISASSEMBLY )
- REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD (for 60/40 Split Seat Type) (See DISASSEMBLY )
- REMOVE REAR DOOR SCUFF PLATE RH (See REMOVAL )
- REMOVE REAR DOOR SCUFF PLATE LH (See REMOVAL )
- REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
- Remove the rear door opening trim weatherstrip to the extent that the rear seat side cover and the roof side inner garnish.
- REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
HINT:
Use the same procedure as for the RH side.
- REMOVE REAR SEAT SIDE COVER RH (See REMOVAL )
- REMOVE REAR SEAT SIDE COVER LH (See REMOVAL )
- REMOVE ROOF SIDE INNER GARNISH RH (See REMOVAL )
- REMOVE ROOF SIDE INNER GARNISH LH (See REMOVAL )
- REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY (w/o Rear Spoiler) (See REMOVAL )
- REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
- Using a clip remover, remove the 4 clips.
- Disengage the 5 claws and remove the package tray trim panel.
- REMOVE PACKAGE TRAY TRIM PAD
- Remove the pack age tray trim pad.
- REMOVE REAR SPEAKER ASSEMBLY
- Disconnect the speaker connector.
- Remove the 4 bolts and the rear speaker.