Brake Pedal Support: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PAN EL (for Sedan) (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE INSTRUMENT CLUSTER FINISH PANEL
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE COMBINATION METER ASSEMBLY
Hatchback: See REMOVAL

Sedan: See REMOVAL
SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Hatchback: See REMOVAL

Sedan: See REMOVAL
SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE FRONT PILLAR GARNISH RH
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE FRONT PILLAR GARNISH LH
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE NO. 1 SWITCH HOLE BASE (for Hatchback) (See REMOVAL )
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Hatchback: See REMOVAL

Sedan: See REMOVAL
REMOVE COLUMN HOLE COVER SILENCER SHEET (See REMOVAL )
REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY (See REMOVAL )
REMOVE STOP LIGHT SWITCH
1. Disconnect the connector from the stop light switch.
2. Disconnect the wire harness clamp from the pedal support.
  
  Fig 1: Locating Stop Light Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Turn the stop light switch counterclockwise, and remove the stop light switch.
  
  Fig 2: Turning Stop Light Switch Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
1. Remove the stop light switch mounting adjuster from the pedal support.
  
  Fig 3: Locating Stop Light Switch Mounting Adjuster
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
1. Remove the brake pedal return spring.
2. Remove the clip and the push rod pin and separate the push rod clevis from the brake pedal.
  
  Fig 4: Locating Brake Pedal Return Spring, Clip & Push Rod Pin
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BRAKE PEDAL SUPPORT
1. Remove the 4 nuts and bolt and remove the pedal support.
REMOVE BRAKE PEDAL
1. Remove the nut and brake pedal shaft and remove the brake pedal from the pedal support.
REMOVE BRAKE PEDAL BUSH
1. Remove the 2 brake pedal bushes from the brake pedal.
REMOVE BRAKE PEDAL PAD
1. Remove the brake pedal pad from the brake pedal.
  
  Fig 5: Locating Brake Pedal Support Nuts & Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002