Blower Resistor: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH (for Hatchback) (See REMOVAL )
REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH (for Sedan) (See REMOVAL )
REMOVE BLOWER RESISTOR
1. Pull back the floor carpet.
  
  Fig 1: Pulling Back Floor Carpet
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the connector.
3. Remove the 2 screws and the blower resistor.
  
  Fig 2: Identifying Screws And Blower Resistor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002