QUARTER TRIM SPEAKER (for Hatchback 3 Door): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Always use "Torx" socket wrench E10 when installing the rear seat.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

INSTALL REAR SPEAKER ASSEMBLY
1. Engage the 2 claws of the speaker with the body and provisionally install the speaker.
  
  Fig 1: Identifying Rear Speaker Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using an air riveter or hand riveter, install the rear speaker assembly onto the quarter panel with 3 new strike rivets.
  HINT:
  
  Install the new strike rivets in order as shown in the illustration.
  
  Fig 2: Installing Strike Rivets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
    
    Fig 3: Precaution For Installation Of Rivets (1 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Confirm that the rivets are seated properly against the speaker.
  - Do not tilt the riveter when installing the rivet onto the speaker.
  - Do not leave any space between the rivet head and speaker.
    
    Fig 4: Precaution For Installation Of Rivets (2 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.
    
    Fig 5: Precaution For Installation Of Rivets (3 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the speaker connector.
INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (See INSTALLATION )
INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type)
1. for RH Side:
  1. Install the rear seat assembly INSTALLATION .
2. for LH Side:
  1. Install the rear seat assembly (See INSTALLATION ).
INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type)
1. for RH Side:
  1. Install the No. 1 rear seat leg cover INSTALLATION .
2. for LH Side:
  1. Install the No. 1 rear seat leg cover (See INSTALLATION ).
INSTALL REAR SEATBACK ASSEMBLY (for Hold Down Seat Type) INSTALLATION
INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type) INSTALLATION
INSTALL DECK FLOOR BOX
1. for RH Side:
  1. Install the deck floor box (See INSTALLATION ).
2. for LH Side:
  1. Install the deck floor box.
    HINT:
    
    Use the same procedure as for the RH side.
INSTALL DECK BOARD SUB-ASSEMBLY (See INSTALLATION )
INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)