Seat Position Sensor: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

NOTE: Always use "Torx" socket wrench E10 when removing the front seat.

HINT:

Installation is in the reverse order of removal.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT SEAT HEADREST ASSEMBLY (for Sedan) REMOVAL
REMOVE FRONT SEAT HEADREST ASSEMBLY (for Hatchback) REMOVAL
REMOVE FRONT SEAT ASSEMBLY LH (for Sedan) REMOVAL
REMOVE FRONT SEAT ASSEMBLY LH (for Hatchback) REMOVAL
REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR
1. Remove the seat slide position sensor protector from the seat position airbag sensor.
REMOVE SEAT POSITION AIRBAG SENSOR
1. Disconnect the connector from the seat position airbag sensor.
2. Using "Torx" socket wrench T30, remove the Torx screw and the seat position airbag sensor.