LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 215 (Seat) >> FRONT SEAT ASSEMBLY (for Sedan) >> Removal

FRONT SEAT ASSEMBLY (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag). (See PRECAUTION )
NOTE: Always use "Torx" socket wrench E10 when removing the front seat.

HINT:

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).
  2. REMOVE FRONT SEAT HEADREST ASSEMBLY 
    1. Push in the lock button of the front seat headrest support and remove the front seat headrest.
      Fig 1: Identifying Front Seat Headrest Lock Button
      G04834203Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT SEAT ASSEMBLY 
    1. for Driver Side:
      1. Using a clip remover, remove the clamp.
      2. w/ Front Seat Side Airbag:
        1. Slide the slider and disconnect the airbag connector.
      3. Disconnect the buckle switch connector.
        Fig 2: Locating Airbag Connector (Driver Side)
        G04834204Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for Front Passenger Side:
      1. Using a clip remover, remove the clamp.
      2. w/ Front Seat Side Airbag:
        1. Slide the slider and disconnect the airbag connector.
      3. Disconnect the buckle switch connector.
      4. Disconnect the occupant detection ECU connector.
        Fig 3: Locating Airbag Connector (Front Passenger Side)
        G04834205Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Move the front seat to its most rearward position.
    4. Using "Torx" socket wrench E10, remove the 2 bolts from the front side.
    5. Move the front seat to its most forward position.
    6. Using "Torx" socket wrench E10, remove the 2 bolts from the rear side.
    7. Remove the front seat.