SIDE AIRBAG SENSOR (for 3 Door): Removal
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Some of the these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See AIRBAG SYSTEM
).
NOTE:
Always use "Torx" socket wrench E10 when removing the rear seat.
HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (See REMOVAL )
- REMOVE DECK BOARD SUB-ASSEMBLY (See REMOVAL )
- REMOVE DECK FLOOR BOX RH (See REMOVAL )
- REMOVE DECK FLOOR BOX LH (See REMOVAL )
- REMOVE NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See REMOVAL )
- REMOVE NO. 2 REAR SEAT LEG COVER (See REMOVAL )
- REMOVE REAR SEAT ASSEMBLY RH (for 60/40 Split Seat Type) (See REMOVAL )
- REMOVE REAR SEAT ASSEMBLY LH (for 60/40 Split Seat Type) (See REMOVAL )
- REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type) (See REMOVAL )
- REMOVE REAR SEATBACK ASSEMBLY (for Hold Down Seat Type) REMOVAL
- REMOVE FRONT DOOR SCUFF PLATE RH (See REMOVAL )
- REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH (See REMOVAL )
- REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH (See REMOVAL )
- REMOVE SIDE AIRBAG SENSOR CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
- Slide the outer housing and detach the airbag connector.
- Remove the bolt, disengage the hook and remove the side airbag sensor.