LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Supplemental Restraint System) >> REAR AIRBAG SENSOR (for Sedan) >> Installation

REAR AIRBAG SENSOR (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See AIRBAG SYSTEM  ).
NOTE: Always use "Tone" socket wrench E10 when removing the rear seat.

HINT:

The procedure described below is for the RH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.

  1. INSTALL REAR AIRBAG SENSOR 
    1. Confirm that the ignition switch is turned to off.
    2. Confirm that the negative battery terminal is detached.
      CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    3. Insert the hook into the body hole and install the airbag sensor with the bolt.

      Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf) 

      NOTE:
      • Do not use a rear airbag sensor that has been dropped.
      • Do not subject the rear airbag sensor to any impact or force.
      4. Fig 1: Identifying Airbag Sensor Bolt
      G04830482Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Confirm that there is no looseness by shaking the rear airbag sensor.
    5. Connect the airbag connector.
      6. Fig 2: Detaching Airbag Connector
      G04830481Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL REAR SEAT SIDE COVER RH  (See INSTALLATION )
  3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  4. INSTALL REAR DOOR SCUFF PLATE RH  (See INSTALLATION )
  5. INSTALL LUGGAGE COMPARTMENT TRIM INNER PAD (for 60/40 Split Seat Type)  (See INSTALLATION )
  6. INSTALL SPARE WHEEL COVER ASSEMBLY (for 60/ 40 Split Seat Type)  (See INSTALLATION )
  7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT (for 60/40 Split Seat Type)  (See INSTALLATION )
  8. INSTALL REAR SEATBACK ASSEMBLY RH (for 60/ 40 Split Seat Type)  INSTALLATION 
  9. INSTALL REAR SEATBACK ASSEMBLY LH (for 60/40 Split Seat Type)  (See INSTALLATION )
  10. INSTALL REAR SEATBACK ASSEMBLY (for Fixed Seat Type)  INSTALLATION 
  11. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY  (See INSTALLATION )
  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  13. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM  )

scientia non olet · About LEMON Manuals