LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Supplemental Restraint System) >> CENTER AIRBAG SENSOR ASSEMBLY (for Sedan) >> Removal

CENTER AIRBAG SENSOR ASSEMBLY (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See AIRBAG SYSTEM  ).
  1. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER  (See REMOVAL )
  2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)  (See REMOVAL )
  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE CONSOLE BOX CARPET  (See REMOVAL )
  7. REMOVE REAR CONSOLE BOX ASSEMBLY  (See REMOVAL )
  8. REMOVE INSTRUMENT PAD LOWER LH  (See REMOVAL )
  9. REMOVE CENTER AIRBAG SENSOR ASSEMBLY 
    CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    1. Pull the lever down and detach the connector holder.
      Fig 1: Detaching Connector Holder
      G04830436Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts and remove the airbag sensor.
scientia non olet · About LEMON Manuals