Headlight Dimmer Switch: Removal
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (see
PRECAUTION
).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
- POSITION FRONT WHEELS FACING STRAIGHT AHEAD
- REMOVE STEERING PAD (See REMOVAL )
- REMOVE STEERING WHEEL ASSEMBLY (for Hatchback) REMOVAL
- REMOVE STEERING WHEEL ASSEMBLY (for Sedan) REMOVAL
- REMOVE STEERING COLUMN COVER (for Hatchback) REMOVAL
- REMOVE STEERING COLUMN COVER (for Sedan) REMOVAL
- REMOVE SPIRAL CABLE (See REMOVAL )
- REMOVE WIPER SWITCH
- Disconnect the 2 connectors.
- Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the wiper switch.NOTE: Do not press the claw too hard, as it may be damaged.
- REMOVE HEADLIGHT DIMMER SWITCH
- Disconnect the connector.
- Remove the headlight dimmer switch, as shown in the illustration.
- Disengage the 2 claws and remove the headlight dimmer switch.