REAR DOOR LOCK (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR DOOR LOCK
NOTE:
- If reusing a door lock that has been removed, replace the packing in the connecting part with new.
- Make sure that no grease or dirt adheres to the packing surface in the connecting part.
1. Apply MP grease to the sliding and rotating areas of the front door lock.
2. Connect the rear door lock remote control cable and rear door inside locking cable.
  
  Fig 1: Locating Rear Door Lock Remote Control Cable And Rear Door Inside Locking Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Close the 2 covers.
4. Insert the door lock into the outside handle frame release plate, then set it onto the door panel.
5. Make sure that the outside handle frame link is securely engaged with the door lock.
6. Apply adhesive to the threads of the screws.
  Adhesive:
  
  Toyota Genuine Adhesive 1324, Three Bond 1324 or the equivalent.
  
  Fig 2: Locating Covers
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Using "Torx" socket wrench T30, install the rear door lock with the 3 screws.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 3: Locating "Torx" Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR DOOR GLASS SUB-ASSEMBLY REASSEMBLY
INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY REASSEMBLY
INSTALL REAR DOOR GLASS RUN REASSEMBLY
INSTALL REAR DOOR BELT MOULDING (See INSTALLATION )
INSTALL REAR DOOR WEATHERSTRIP REASSEMBLY
INSTALL REAR DOOR CHECK ASSEMBLY REASSEMBLY
INSTALL REAR DOOR SERVICE HOLE COVER REASSEMBLY
INSTALL REAR DOOR TRIM BRACKET REASSEMBLY
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY REASSEMBLY
INSTALL REAR DOOR ARMREST BASE UPPER PANEL REASSEMBLY
INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) REASSEMBLY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)