REAR DOOR BELT MOLDING (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

Fig 1: Identifying Rear Door Belt Molding

INSTALL REAR DOOR BELT MOLDING
1. Engage the 5 claws and install a new rear door belt molding.
  
  Fig 2: Identifying Rear Door Belt Molding
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the protective tape.
  
  Fig 3: Applying Protective Tape To Door Panel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002