FRONT DOOR LOCK (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT DOOR LOCK
NOTE:
- If reusing a door lock that has been removed, replace the packing in the connecting part with new.
- Make sure that no grease or dirt adheres to the packing surface in the connecting part.
1. Apply MP grease to the sliding and rotating areas of the front door lock.
2. Connect the front door lock remote control cable and the front door inside locking cable.
  
  Fig 1: Locating Front Door Lock Remote Control Cable And Front Door Inside Locking Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Close the cover.
  
  Fig 2: Locating Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Insert the door lock open rod into the front door lock, then set it to the door panel.
  NOTE: Make sure that the outside handle link is securely engaged with the door lock.
  
  Fig 3: Inserting Door Lock Open Rod Into Front Door Lock
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Apply adhesive to the threads of the screws.
  Adhesive:
  
  Toyota Genuine Adhesive 1324, Three Bond 1324 or the equivalent.
6. Using "Torx" socket wrench T30, install the front door lock with the 3 screws.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 4: Locating Front Door Lock Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR OUTSIDE HANDLE COVER (See REASSEMBLY )
INSTALL FRONT DOOR FRAME SUB-ASSEMBLY REAR LOWER (See REASSEMBLY )
INSTALL FRONT DOOR GLASS RUN (See REASSEMBLY )
INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR SERVICE HOLE COVER (See REASSEMBLY )
INSTALL FRONT DOOR TRIM BRACKET (See REASSEMBLY )
INSTALL FRONT DOOR BELT MOULDING (See INSTALLATION )
INSTALL OUTER REAR VIEW MIRROR (See INSTALLATION )
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT ARMREST BASE UPPER PANEL (See REASSEMBLY )
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (See REASSEMBLY )
INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)