OUTER REAR VIEW MIRROR (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL OUTER MIRROR COVER
1. Engage the claw on the lower part of the mirror cover.
2. Engage the claw on the upper part of the mirror cover.
3. After installing the outer mirror cover, check that there are no gaps between the cover and the mirror body.
  NOTE: If there is a gap between the cover and the mirror body, it may cause noise during driving.
4. Engage the 2 claws of the outer rear view mirror.
5. Engage the 2 clips and install the mirror.
  
  Fig 1: Identifying Mirror Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL OUTER REAR VIEW MIRROR
1. Engage the claw and install the outer rear view mirror with the 3 nuts.
  Torque: 8.0 N.m (82 kgf*cm, 71 in.*lbf)
2. w/ Power mirror:
  Connect the connector.
  
  Fig 2: Locating Mirror Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (See REASSEMBLY )
INSTALL FRONT ARMREST BASE UPPER PANEL (See REASSEMBLY )
INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N.m (55 kgf*cm, 48 in.*lbf)