FRONT DOOR BELT MOLDING (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

Fig 1: Identifying Front Door Belt Molding

INSTALL FRONT DOOR BELT MOLDING
1. Engage the 6 claws and install a new front door belt molding.
  
  Fig 2: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the protective tape.
INSTALL OUTER REAR VIEW MIRROR ASSEMBLY INSTALLATION
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR ARMREST BASE UPPER PANEL (See REASSEMBLY )
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (See REASSEMBLY )

Fig 3: Applying Protective Tape To Door Panel
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)