LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Supplemental Restraint System) >> Rear Airbag Sensor >> Installation

Rear Airbag Sensor: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).
Fig 1: Locating Airbag Sensor Rear LH Bolt
G05184700Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. INSTALL AIRBAG SENSOR REAR LH 
    1. Install the airbag sensor with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

    NOTE:
    • If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    • When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
    Fig 2: Locating Airbag Sensor Rear LH Bolt
    G05184700Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat)  (see INSTALLATION )
  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/ o Rear No. 2 Seat)  (see INSTALLATION )
  4. CONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (w/ Rear No. 2 Seat) 
  5. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH  (see INSTALLATION )
  6. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL LH (w/o Rear No. 2 Seat) 
  7. INSTALL REAR FLOOR FINISH PLATE  (see INSTALLATION )
  8. INSTALL REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE  (see INSTALLATION )
  9. INSTALL REAR FLOOR NO. 3 BOARD 
  10. INSTALL REAR FLOOR NO. 2 BOARD 
  11. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat)  (see INSTALLATION )
  12. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear NO. 2 Seat)  (see INSTALLATION )
  13. INSTALL NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat)  (see INSTALLATION )
  14. INSTALL NO. 2 SEAT LEG COVER RH (w/ Rear No. 2 Seat)  (see INSTALLATION )
  15. INSTALL NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat)  (see INSTALLATION )
  16. INSTALL NO. 2 SEAT HINGE COVER RH (w/ Rear No. 2 Seat)  (see INSTALLATION )
  17. INSTALL DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat) 
  18. INSTALL REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat) 
  19. INSTALL TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat) 
  20. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/o Rear No. 2 Seat) 
  21. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH 
  22. INSTALL REAR DOOR SCUFF PLATE LH  (see INSTALLATION )
  23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  24. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see PROBLEM SYMPTOMS TABLE ).
scientia non olet · About LEMON Manuals