LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Tire & Wheel) >> TIRE PRESSURE WARNING RECEIVER (w/Antenna) >> Installation

TIRE PRESSURE WARNING RECEIVER (w/Antenna): Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TIRE PRESSURE WARNING ANTENNA AND RECEIVER 
    1. Install the receiver with the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the connector.
      Fig 1: Installing Receiver With Bolt
      G04489318Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH (See appropriate step(s) under  INSTALLATION  ) 
  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (w/o Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (w/Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  5. INSTALL TETHER ANCHOR BRACKET SUBASSEMBLY (w/o Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  6. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL RH (w/o Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  7. INSTALL REAR DECK TRIM COVER RH (w/Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  8. INSTALL REAR FLOOR FINISH PLATE (See appropriate step(s) under  INSTALLATION  ) 
  9. INSTALL REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE See appropriate step(s) under  INSTALLATION  ) 
  10. INSTALL REAR FLOOR NO. 2 BOARD 
  11. INSTALL REAR FLOOR NO. 3 BOARD 
  12. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (w/Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  13. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (w/Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  14. INSTALL NO. 2 SEAT LEG COVER LH (w/Rear No. 2 Seat) (See  INSTALLATION  ) 
  15. INSTALL NO. 2 SEAT LEG COVER RH (w/Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  16. INSTALL NO. 2 SEAT HINGE COVER LH (w/Rear No. 2 Seat) (See  INSTALLATION  ) 
  17. INSTALL NO. 2 SEAT HINGE COVER RH (w/Rear No. 2 Seat) (See appropriate step(s) under  INSTALLATION  ) 
  18. INSTALL DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat) 
  19. INSTALL REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat) 
  20. INSTALL TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat) 
  21. INSTALL PACKAGE TRAY TIRM POCKET SUBASSEMBLY (w/o Rear No. 2 Seat) 
  22. INSTALL REAR DOOR SCUFF PLATE RH See appropriate step(s) under  INSTALLATION  ) 
  23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  24. REGISTER TRANSMITTER ID (See  REGISTRATION  ) 
  25. INSPECT TIRE PRESSURE WARNING SYSTEM 
scientia non olet · About LEMON Manuals