LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tire & Wheel (Except Hybrid) >> Tire Pressure Warning Ecu >> Removal

Tire Pressure Warning Ecu: Removal

NOTE: Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of transmitter IDs (See REGISTRATION  ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT DOOR SCUFF PLATE RH  (See REMOVAL )
  3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH  (See REMOVAL )
  4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE LOWER INSTRUMENT PANEL SUBASSEMBLY (for TMC Made)  (See REMOVAL )
  6. REMOVE LOWER INSTRUMENT PANEL SUBASSEMBLY (for TMMK Made)  (See REMOVAL )
  7. REMOVE TIRE PRESSURE WARNING ECU 
    1. Remove the nut.
    2. Disconnect the connector and remove the tire pressure warning ECU.
      Fig 1: Locating Tire Pressure Warning ECU Connector
      G04977881Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals