Tire Pressure Warning Ecu: Installation

INSTALL TIRE PRESSURE WARNING ECU
1. Connect the connector to the tire pressure warning ECU.
2. Install the tire pressure warning ECU with the nut.
  Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf)
  
  Fig 1: Locating & Installing Tire Pressure Warning ECU Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL SUBASSEMBLY (for TMC Made) (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL SUBASSEMBLY (for TMMK Made) (See INSTALLATION )
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE RH (See INSTALLATION )
CONNECT CABLE TO BATTERY NEGATIVE TERMINAL
REGISTER TRANSMITTER ID
HINT:

(See REGISTRATION )
INITIALIZE SYSTEM
NOTE:
- Be sure to register the transmitter IDs of all tires including the grand spare tire in the ECU before initialization.
- Be sure to inflate all tires including the grand spare tire to the proper inflation pressure before initialization.
HINT:

(See INITIALIZATION )
INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:

(See TEST MODE PROCEDURE )