LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 67 (Engine Control System (2GR-FE Except Hybrid) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation) >> ECM >> Removal

Section 67 (Engine Control System (2GR-FE Except Hybrid) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation): ECM: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  2. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH  (See REMOVAL )
  4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH  (See REMOVAL )
  5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE WINDSHIELD WIPER MOTOR AND LINK  (See REMOVAL )
  7. REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY (See  REMOVAL   ) 
  8. REMOVE ECM 
    1. Remove the 3 nuts.
      Fig 1: Locating ECM Nuts
      G04973912Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the 2 ECM connectors and remove the ECM.
      1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.
        NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter do not contact the connecting part of the connector.
        Fig 2: Removing ECM
        G04973913Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the ECM.
    3. Remove the 4 screws and 2 ECM brackets.
      Fig 3: Locating ECM Brackets Screws
      G04973914Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals