LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System (2AZ-FE) (Except Hybrid) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT WHEEL RH 
  3. REMOVE FRONT FENDER APRON RH 
  4. REMOVE V-RIBBED BELT  (See REMOVAL )
  5. REMOVE GENERATOR ASSEMBLY  (See REMOVAL )
  6. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the connector clamp and wire harness clamp.
    3. Remove the wire harness clamp bracket from the wire harness.
    4. Remove the bolt, and then remove the crankshaft position sensor.
      Fig 1: Locating Connector Clamp, Wire Harness Clamp And Crankshaft Position Sensor
      G04973360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals