LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System (2AZ-FE) >> Generator >> Removal

Charging System (2AZ-FE): Generator: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT WHEEL RH 
  3. REMOVE ENGINE UNDER COVER RH 
  4. REMOVE FRONT FENDER APRON SEAL RH 
  5. REMOVE V-RIBBED BELT  (See REMOVAL )
  6. REMOVE GENERATOR ASSEMBLY 
    1. Disconnect the generator connector.
    2. Remove the nut and disconnect the wire harness from terminal B.
      Fig 1: Identifying Wire Harness From Terminal B Nut
      G04975721Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and wire harness clamp bracket.
    4. Remove the wire harness clamps.
    5. Remove the 2 bolts and generator assembly.
    Fig 2: Locating Generator Assembly Bolts
    G04975722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals