LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (2AZ-FE) >> Drive Belt >> Removal

Drive Belt: Removal

  1. REMOVE FRONT WHEEL RH 
  2. REMOVE ENGINE UNDER COVER RH 
  3. REMOVE FRONT FENDER APRON SEAL RH 
  4. REMOVE V-RIBBED BELT 
    1. Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.

      SST 09216-42010 

      NOTE:
      • Be sure to connect SST and the tools so that they are in line during use.
      • When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
      • After the tensioner is fully retracted, do not apply force any more than necessary.
      Fig 1: Removing V-Ribbed Belt With SST
      G04973929Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals