Rear Axle Hub And Bearing: Installation

INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
1. Install the hub and bearing assembly with the 4 bolts.
  Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf)
2. Connect the skid control sensor connector.
  NOTE: Do not twist the sensor wire when connecting it.
  
  Fig 1: Locating Bearing Assembly Hub Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT REAR AXLE HUB BEARING LOOSENESS (See ON-VEHICLE INSPECTION )
INSPECT REAR AXLE HUB RUNOUT (See ON-VEHICLE INSPECTION )
INSTALL REAR DISC (See REASSEMBLY )
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (See INSTALLATION )
CONNECT SKID CONTROL SENSOR CONNECTOR (See INSTALLATION )
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CHECK ABS SPEED SENSOR SIGNAL
1. ABS: See TEST MODE PROCEDURE
2. VSC (for BOSCH): See TEST MODE PROCEDURE
3. VSC (for ADVICS): See TEST MODE PROCEDURE