Stop Light Switch: Installation

INSTALL STOP LIGHT SWITCH
1. Insert the stop light switch assembly until the body hits the cushion.
  NOTE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
  
  Fig 1: Inserting Stop Light Switch Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Make a quarter turn clockwise to install the stop light switch assembly.
  Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) or less
  
  Fig 2: Installing Stop Light Switch Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
3. Connect the stop light switch connector to the stop light switch assembly.
  
  Fig 3: Connecting Stop Light Switch Connector To Stop Light Switch Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Check the protrusion of the rod (See ON-VEHICLE INSPECTION ).
INSTALL COMBINATION METER (See INSTALLATION )
INSTALL INSTRUMENT CLUSTER FINISH PANEL (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System) (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System) (See INSTALLATION )
INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (See INSTALLATION )
INSTALL COWL SIDE TRIM SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (See INSTALLATION )