REAR NO. 1 SUSPENSION ARM (for 2WD): Installation

TEMPORARILY TIGHTEN REAR SUSPENSION NO. 1 ARM
1. Install the rear suspension arm No. 1 (inner side) with the bolt, and temporarily tighten the bolt.
  
  Fig 1: Locating Rear Suspension Arm No. 1 (Inner Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Ensure that the paint mark faces to the rear of the vehicle.
2. Connect the rear suspension arm No. 1 (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt and nut.
  NOTE: When temporarily tightening the bolt, keep the nut from rotating.
STABILIZE SUSPENSION (See INSTALLATION )

Fig 2: Locating Rear Wheel Alignment
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FULLY TIGHTEN REAR SUSPENSION NO. 1 ARM
1. Fully tighten the bolt.
  Torque: 120 N*m (1,220 kgf*cm, 89 ft.*lbf)
  
  Fig 3: Locating Rear Suspension Arm No. 1 (Inner Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the bolt.
  Torque: 112 N*m (1,140 kgf*cm, 83 ft.*lbf)
  
  Fig 4: Locating Rear Wheel Alignment
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR STABILIZER BUSHING (See REMOVAL )
INSTALL REAR STABILIZER BAR BRACKET (See REMOVAL )
INSTALL REAR STABILIZER BAR (See INSTALLATION )
INSTALL REAR STABILIZER LINK ASSEMBLY LH (See INSTALLATION )
INSTALL REAR STABILIZER LINK ASSEMBLY RH (See INSTALLATION )
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(See ADJUSTMENT )