REAR STABILIZER BAR (for 2WD): Installation

1. Install 2 rear stabilizer bushings to the outer side of the stopper ring on the stabilizer bar.
   Fig 1: Installing Rear Stabilizer Bushing

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the 2 rear stabilizer bar brackets.

1. Install the rear stabilizer bar with the 4 bolts.

   Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

   Fig 2: Locating Rear Stabilizer Bar

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the rear stabilizer link assembly LH with the 2 nuts.

   Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf) 

   Fig 3: Locating Rear Stabilizer Link Assembly Rh

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT:

   If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.

1. Install the rear stabilizer link assembly RH with the 2 nuts.

   Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf) 

   HINT:

   If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)