REAR STABILIZER BAR (for 2WD): Removal

1. Remove the 2 nuts and rear stabilizer link assembly LH.

HINT:

If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.

1. Remove the 2 nuts and rear stabilizer link assembly RH.
   Fig 1: Locating Rear Stabilizer Link Assembly Rh

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT:

   If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.

1. Remove the 4 bolts and rear stabilizer bar.
   Fig 2: Locating Rear Stabilizer Bar

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 rear stabilizer bar brackets.

1. Remove the 2 rear stabilizer bushings from the rear stabilizer bar.