LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt (Hybrid) >> Front Seat Outer Belt Assembly With PRETENSIONER >> Removal

Front Seat Outer Belt Assembly With PRETENSIONER: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag from deploying (See AIRBAG SYSTEM ).
  2. REMOVE FRONT DOOR SCUFF PLATE 

    w/o Rear No.2 seat (See REMOVAL )

    w/ Rear No.2 seat (See REMOVAL )

  3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP 

    w/o Rear No.2 seat (See REMOVAL )

    w/ Rear No.2 seat (See REMOVAL )

  4. REMOVE REAR DOOR SCUFF PLATE 

    w/o Rear No.2 seat (See REMOVAL )

    w/ Rear No.2 seat (See REMOVAL )

  5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP 

    w/o Rear No.2 seat (See REMOVAL )

    w/ Rear No.2 seat (See REMOVAL )

  6. REMOVE CENTER PILLAR GARNISH LOWER 

    w/o Rear No.2 seat (See REMOVAL )

    w/ Rear No.2 seat (See REMOVAL )

  7. REMOVE LAP BELT OUTER ANCHOR COVER 
    1. Disengage the 2 claws and remove the lap belt outer anchor cover.
      Fig 1: Identifying Claws On Lap Belt Outer Anchor Cover
      G05242872Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE SEAT BELT ANCHOR COVER CAP 
    1. Using a screwdriver, disengage the 4 claws and remove the seat belt anchor cover cap.
      Fig 2: Removing Seat Belt Anchor Cover Cap
      G05242873Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      Tape the screwdriver tip before use.

  9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    1. Turn the ignition switch to the LOCK position.
    2. Remove the bolt and floor end of the front seat outer belt assembly.
    3. Remove the bolt and shoulder anchor of the front seat outer belt assembly.
    4. Using a screwdriver, pull the locking tab outward as shown in the left box in the illustration to release the lock, and disconnect the pretensioner connector.

      HINT:

      Tape the screwdriver tip before use.

    5. Disconnect the tension reducer connector shown by the black arrow in the middle of the illustration.
      Fig 3: Disconnecting Pretensioner Connector
      G05242874Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the 2 bolts and front seat outer belt assembly.
      Fig 4: Installing Front Seat Outer Belt Assembly
      G05242875Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002