LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Power Outlet (Hybrid) >> Rear Power Point Socket >> Removal

Rear Power Point Socket: Removal

  1. REMOVE TONNEAU COVER ASSEMBLY 
  2. REMOVE DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)  (See REMOVAL )
  3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Rear No. 2 Seat)  (See REMOVAL )
  4. REMOVE DECK BOARD SUB-ASSEMBLY NO.3 
  5. REMOVE DECK BOARD SUB-ASSEMBLY NO.2 
  6. REMOVE DECK FLOOR BOX REAR  (See REMOVAL )
  7. REMOVE DECK FLOOR BOX FRONT (w/o Rear No. 2 Seat)  (See REMOVAL )
  8. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
  9. REMOVE REAR SEAT RECLINING COVER NO.2 LH (w/ Rear No. 2 Seat)  (See REMOVAL )
  10. REMOVE DECK SIDE TRIM BOX LH  (See REMOVAL )
  11. REMOVE REAR SEAT TRACK COVER LH (w/ Rear No. 2 Seat) 
  12. REMOVE SEAT TRACK COVER INNER LH (w/ Rear No. 2 Seat) 
  13. REMOVE REAR DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)  (See REMOVAL )
  14. REMOVE REAR DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)  (See REMOVAL )
  15. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH 
  16. REMOVE BACK DOOR WEATHERSTRIP 
  17. REMOVE ROPE HOOK  (See REMOVAL )
  18. REMOVE DECK SIDE TRIM COVER LH (w/o Rear No. 2 Seat)  (See REMOVAL )
  19. REMOVE DECK SIDE TRIM COVER LH (w/ Rear No. 2 Seat)  (See REMOVAL )
  20. REMOVE REAR COMBINATION LIGHT SERVICE COVER LH 
  21. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/o Rear No. 2 Seat)  (See REMOVAL )
  22. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat)  (See REMOVAL )
  23. REMOVE REAR POWER POINT SOCKET 
    1. Using a screwdriver, disengage the claw on the rear power point socket cover from the hole in the rear power point socket. Then pull out the rear power point socket approximately 10 mm (0.39in.).

      HINT:

      Tape the screwdriver tip before use.

      Fig 1: Removing Claw On Rear Power Point Socket Cover From Hole
      G05243856Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, disengage the claw on the rear power point socket cover from body and remove the rear power point socket and cover as a unit.
      3. Fig 2: Disengaging Claw On Rear Power Point Socket Cover From Body
      G05243857Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the connector.
    4. Disassemble the rear power point socket from the rear power point socket cover.
scientia non olet · About LEMON Manuals